![]() If you are already good at pulling focus, then this makes recording a focus pull live even easier. Adding the hand controller gives a user another option for controlling and setting up programmed shots. The kit we recommend also includes a hand controller. These motors can serve as any two of the following: Focus motor, Zoom motor, or Iris motor. In this configuration, you will be using TWO Tilta Nucleus-M Motors (+ Hand Controller). If one rail/motor is mounted to the upper portion of the L Bracket, and the other rail/motor is mounted to the lower portion of the L Bracket, then likely 18cm will prove to be insufficient.Ĭonfiguration 3: Add two Tilta Nucleus-M Motors with the Hand Controller User B might want to run two different rails (one for each motor). In that instance, the 18cm cable would be more than enough to chain Motor 1 to Motor 2. We say this because hypothetically, User A might find it ideal to line both of their motors up RIGHT next to each other. The cables that chain the motors together CAN be shorter if desired but please take real-world measurements and plan around a lens that you intend on using. If you are ordering a replacement cable to run between your first Tilta motor and the ST4.3, use the guide below. The cable that runs between the ST4.3 and the first Tilta Nucleus-M MUST BE 55cm in length. We recommend purchasing TWO of the single motor kits listed below.Ģ.1 First Nucleus-M Motor Kit I – SKU: WLC-T03-M1 WLC-T03-M1Ģ.1 Second Nucleus-M Motor Kit I – SKU: WLC-T03-M1 WLC-T03-M1Ĭurrently, Tilta is including a 55cm 7-pin to 7-pin cable with their individual motors and with the kit. In this configuration, you will be using two Tilta Nucleus-M Motors. When hooked up to the spectrum, that single cable is all you need to connect the ST4.3's EXT port to either port of the Nucleus-M Motor.Ĭonfiguration 2: Add two Tilta Nucleus-M Motors WLC-T03-M1 Nucleus-M Motor Kit I – SKU: WLC-T03-M1 This kit includes a single Tilta Nucleus-M Motor and the 7-pin to 7-pin 55cm cable (both seen in the photo below) You will need two pieces of equipment (sold as a single kit directly from Tilta – linked below). This motor can serve as EITHER a focus motor, a zoom motor, or an iris motor. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |